Verex Monitor ISM Guida di Installazione

Simplified Installation Guide rev1.3 These instructions are used for both the Open xL and Monitor xL v

4 xL Simplified Installation Guide 21-3601E rev1.3 312TB2TB1312 312 312 12 312 312 312 312 312 312312312 4 312 4TB3TB4TB5TB6 TB7TB8 TB9 TB10TB11 TB

21-3601E rev1.3 xL Simplified Installation Guide 5 North American Modem (Bell 103, 300 baud) For Director Software Communications to Feature set 3

6 xL Simplified Installation Guide 21-3601E rev1.3 STU (subscriber terminal unit) Enable Equipment failure point E16 (HSC, Security IP, Trouble). Se

21-3601E rev1.3 xL Simplified Installation Guide 7 Total current draw with the auxiliary and module bus must not exceed 1.0A Europe For units that

8 xL Simplified Installation Guide 21-3601E rev1.3 VBUS • VBUS is an internal communication bus that related VBUS modules are used with. The VBUS i

21-3601E rev1.3 xL Simplified Installation Guide 9 Basic Circuit Types Normally Closed Normally Closed with 2.2 K End of Line Resistor NCNOCOM312

10 xL Simplified Installation Guide 21-3601E rev1.3 Powering on the System for the First Time Understanding How to Program the System Using the LCD

21-3601E rev1.3 xL Simplified Installation Guide 11 Simplified is chosen, ordinary language menus will appear to browse through and make selections

12 xL Simplified Installation Guide 21-3601E rev1.3 Director Options ◄ Update Cfg ► ↓Ok 5) “Director Options”, “Update Config” will display. Pr

21-3601E rev1.3 xL Simplified Installation Guide 13 Simplified Configurations System Siren Time Main Screen Greeting PIN Duress 5 Digit PIN Def

14 xL Simplified Installation Guide 21-3601E rev1.3 Areas ◄ A02 – A16 ► undefined A01 Defaults Press ↓Ok to ◄Edit► Area Name Area Entry Delay S

21-3601E rev1.3 xL Simplified Installation Guide 15 Arm Disarm Map (Arm/Disarm other areas) Press the button below “ÈEdit “ to make changes. Scro

16 xL Simplified Installation Guide 21-3601E rev1.3 North American Point Defaults: Point Location Default Point Type Default Name Default Circuit

21-3601E rev1.3 xL Simplified Installation Guide 17 UK Point Defaults: Point Location Default Point Type Default Name Default Circuit Type Assi

18 xL Simplified Installation Guide 21-3601E rev1.3 Equipment Enabled or Undefined Time Delay E01 System Tamper Siren  Off  Stay 9 On Sonalert 9O

21-3601E rev1.3 xL Simplified Installation Guide 19 Outputs (North America version) Select Output? ◄ B001 ►S000.07 ↓Ok Pre-programmed Output numb

20 xL Simplified Installation Guide 21-3601E rev1.3 B001 – B128 Protection Points Select Point # Normal, Not Normal, Day Not Normal, Nite (Night)

21-3601E rev1.3 xL Simplified Installation Guide 21 UK Input Circuit Types and Defaults Select Circuit Circuit Name Type Resistor Configurations

22 xL Simplified Installation Guide 21-3601E rev1.3 Diagnostics The system is capable of self trouble shooting itself which can be helpful to the te

21-3601E rev1.3 xL Simplified Installation Guide 23 Underwriters’ Laboratories Inc. (U.L.) Listed systems: Notes and Requirements Installation Not

21-3601E rev1.3 (20.5.2008) © 2008 CSG Security Inc. / Sécurité CSG Inc. i Contents Hardware Components...

24 xL Simplified Installation Guide 21-3601E rev1.3 addresses but are under the responsibility of someone having mutual interest (other than the ala

21-3601E rev1.3 xL Simplified Installation Guide 25 11. Provision shall be made for a separate test of detector in each safe or vault connected to

26 xL Simplified Installation Guide 21-3601E rev1.3 Index 5 Digit PIN ... 13

N3459

ii xL Simplified Installation Guide 21-3601E rev1.3 Disclaimer This document contains proprietary information of CSG Security Inc. / Sécurité CSG In

21-3601E rev1.3 xL Simplified Installation Guide iii corporation commission for information.) The xL system complies with the requirements of EN 6

iv xL Simplified Installation Guide 21-3601E rev1.3 CE – Conformity The xL System described in this manual conforms to the requirements of the Coun

21-3601E rev1.3 xL Simplified Installation Guide 1 Hardware Components LCD Keypad 1,- #2ABC3DEF45JKL6MNOGHI78TUV9WXYPRSKeypad LEDsRed Flashing: Pro

2 xL Simplified Installation Guide 21-3601E rev1.3 LCD Keypad Notes When a keypad is first powered It will display “ComsLost # (e.g.) 50624”. The ke

21-3601E rev1.3 xL Simplified Installation Guide 3 Main Control Module NOTE: Any expansion modules used with the xL system, like the 8 and 16 Point